Set Building, Tree
Leave a comment

Making the roots, trunk and brunch

Share on FacebookTweet about this on TwitterPin on Pinterestshare on TumblrGoogle+Share on StumbleUponDigg thisShare on LinkedIn

I used 3 and 2 mm galvanized wire for the roots, trunk and main branches. Calculated how many branhes I would need for the number of wires to be used. I covered each wire with a piece of newspaper. And shaped the tree using masking tape with these newspaper covered wires. For the little branches I used thinner wire and directly covered with masking tape before mounting to the branches. Detailed pictures to come later….

Leave a Reply

Your email address will not be published. Required fields are marked *